Ham holdersPectusPectus Wood PECTUS Ash Tree wooden base
- Ham holder main body made of stainless steel.
- Head with revolving ring system that allows turning the ham without removing it from the ham holder.
- Hiden gear system Pectus hemisphere.
- Ash tree wood base.
- V shaped accessory for front end.
- Swiveling main body. Fully detachable.
The stainless steel main body is diswasher safe. The wooden base and the hemisphere should be cleaned by hand.
Use products recommended for wood cleaning and maintenance. The driping oil from the ham should keep the wood nourished. If the ham holder is not used regulary it will be necessary to wax or to oil the base to prevent drying.
DIMENSIONS:
Full ham holder 9,185kg
Measurements in intermediate position 48x52x25cm
Accessories
-
BASE ENGRAVING with text
The engraving of the base can delay up to 7 days sending the ham holder. During the month of August there is not engraving service. No refund or change of the engraved bases. We recommend to place the engraving on the part that is most visible. Check where your ham holder will be placed, if the back of it is facing a wall or kitchen cabinets the engraving should be on the front. Shops, restaurants and professional ham slicers often place the ham holder with the rear visible to the public, in this case we recommend engraving on the back of the base. Colors shown are approximate. Colors change when applied to different kind of surfaces. Welcome to contact us if you need further information on the engravings.
43,00 € + shipping + tax -
-